The SMI Easy Monitor
"SMI EasyMonitor" allows the bus function of the installation to be checked easily (knowledge of the higher-level building system is not necessary). It is necessary to disconnect the bus connector from the KNX side of the actuator for this purpose.
The software and requisite drivers can be found on this page under Downloads.
Requirements
- Computer with Windows 98, 2000, XP, Windows 7 or higher operating system
- USB interface
- BECKER USB SMI tool 4002 000 004 0
- Can be downloaded free from the homepage
Functions
- Identification of the manufacturer codes
- Identification of the KEY-ID
- Assignment of a slave address
- Commands: UP/DOWN/STOP/STEP-UP/STEP-DOWN

Maik Wiegelmann
Planning Support KNX/SMI (German, English, French, Spanish)
Tel.: +49 (0)2772 / 507-241
Fax: +49 (0)2772/507-299

Oliver Axt
Technical Service – Planning Support KNX/SMI (German and English)
Tel.: +49 (0)2772 / 507-253
Fax: +49 (0)2772/507-259

Pierre Erner
Technical Service – Planning Support KNX/SMI (German and English)
Tel.: +49 (0)2772 / 507-251
Fax: +49 (0)2772/507-259
Certificates


